Error thirty-six (36) means that the bin full sensor for your robot was not cleared when the robot evacuated debris into the Clean Base™. You may see the red Light Ring sweeping towards the rear of the robot.
To clear the error from your robot, ensure the Bin Full Sensors inside the bin well have been properly cleaned. To do so,
remove the Filter from the Bin and
rinse the Bin and bin door with water and let air dry. Next, wipe the Bin Full of Sensors with a clean, dry microfiber or soft cotton cloth.
If the error continues, please perform
Cleaning Head Maintenance.
If you have a Clean base, follow these
maintenance steps to make sure there is no clog in the dock itself. If the robot can't properly evacuate, the bin will remain full and trigger error 36
If the error persists after cleaning the Bin and the Cleaning Head Module, please
reboot your robot.
If the error continues after performing maintenance and rebooting your robot, please contact
iRobot® Customer Care.
For expedited service, please have the following ready:
